Steel mesh is a kind of steel mesh product welded by our factory. It is a steel mesh composed of longitudinal and transverse steel bars arranged at a certain distance and right angle. All intersections are welded together by strong resistance pressure.
Welded steel bar net is regarded as a new type, high efficiency and high quality construction steel of reinforced concrete structure by old grandfather in China. It is widely used in floor, roof, wall, floor, concrete pavement, bridge pavement, Airport runway, tunnel lining, concrete pipeline, pile, etc.
Technical performance and advantages of reinforced concrete welded steel mesh:
1. It can greatly reduce the installation time of steel products, 50%-70% less labor than the binding network.
2. Because of the relatively close spacing of reinforcing bars, the longitudinal and transverse reinforcing bars of the welding network form a network structure, which binds and anchors each other, which is conducive to preventing the occurrence and development of concrete cracks. Welding mesh installed on pavement, floor and floor can reduce cracks on concrete surface by about 75%.
3. It is especially suitable for large area concrete engineering and welding screen hole size is very neat, far beyond manual binding network, meshing stiffness, good elasticity, cast concrete reinforcement is not easy to local bending, deion and sliding phenomenon, concrete cover thickness is easy to control, uniform, significantly improve the quality of reinforced concrete engineering.
4,电焊网具有良好的综合经济效益,焊接网的设计钢筋强度高于一级钢筋(光面钢筋焊接网)50% ~ 70%(竹节钢筋焊接网),考虑一些结构要求后仍可以节省钢材约30%,低于12毫米直径分布钢筋处理费用的约10%至15%的原材料的成本。综合考虑(与一级钢筋相比)可使钢筋工程造价降低10%左右。钢筋焊接网是工厂内焊接的一种网状钢产品，是纵向和横向钢筋按一定的距离相互成直角排列，所有的交点都焊接在一起，具有很强的耐压性。
4. Welded wire mesh has good comprehensive economic benefits. The design strength of welded wire mesh is 50%-70% higher than that of first grade steel (smooth steel wire mesh). Considering some structural requirements, it can still save about 30% of steel and about 10% to 15% of the cost of raw materials for treatment of steel bars with diameter distribution less than 12 mm. Considering comprehensively (compared with the first grade reinforcement), the cost of reinforcement engineering can be reduced by about 10%. Welded steel mesh is a kind of mesh steel products welded in factories. It is arranged at right angles between longitudinal and transverse steel bars according to certain distances. All intersections are welded together, which has strong pressure resistance.